PROBLEM |
CAUSES |
SOLUTIONS |
1. Sore Shoulders |
Pull back force on shoulders from weight behind |
Add Balance Pockets, or if using them, put more weight in them and loosen front shoulder strap webs |
Too much weight on shoulders |
Loosen front shoulder strap webs |
|
Hipbelt has slipped down |
Raise hipbelt & retighten &/or shorten |
|
Balance Pockets are pulling down on bottom of shoulder pads |
Increase back length: Pull up on navy top back panel web |
|
2. Bodypack is too hard to put on |
Incorrect technique used |
1. Loosen hipbelt webs before putting the body pack on for the first time |
2. Follow this sequence: Place hands underneath Balance Pockets; grab hold of hipbelt centre buckles, lift both Pockets & hipbelt up to the right height; clip centre buckle together & tighten the tension web loop at top and bottom to get an even pressure at the top and bottom of the hipbelt |
||
3. When taking the pack off, before releasing the hipbelt centre buckle, loosen the side buckles. With familiarity, you can release the 2 tensionlock buckles on each side with each hand simultaneously, by pulling the buckle ends up. Now you have set the pack up to be easy and quick to put on next time |
||
I do not have the coordination anymore to master this simple sequence |
Substitute Universal Balance Bags for Balance Pockets. These quickly and easily attach after you have put the pack on |
|
My pack leans to one side |
Your pack will lean to one side, like any brand of pack, if you have the shoulder straps and/or hipbelt adjusted unequally on both sides, or you have loaded the pack unevenly. |
First check the top stabiliser straps are equal length and the front shoulder strap webs are also equal length. Now check that the hipbelt parts are adjusted to equal length and angle on both sides of the center base plate and the side tension adjustors (cord or web) are of equal length both sides. Now with all these adjustments made, check that the hipbelt ends are sitting at a similar position on each side of your pelvis with the pack on. Finally, check that your U-Flow movement (the movement when you lift one shoulder), is equal on both sides. With everything centered, including the load, there should be no reason for your pack to lean to one side. |
Shopping Cart:
$ 0.00